After considering various options, you have finally decided it is the right time to carry out window replacement Edmonton. However, deciding to replace your windows and getting into the actual process are two different things. Before, you head to that contractor’s store, you need to have the necessary measurements of your old windows, so you know what to buy. That is why understanding how to measure the windows is essential, especially for homeowners who decide to go the DIY route.
The reasons for measuring windows are that you want the new replacement windows to be consistent with the openings. Taking the right measurements means that your windows would be able to fit snuggly and avoid additional sealing. The measurements also help the contractor know whether you want new insulation or change it. This is essential when it comes to saving on heating and cooling costs; that is all that window replacement Edmonton is geared towards. So, let’s go down with each step.
1. The Tools Needed.
Some of the tools you need to accomplish your measurements undertaking are;
- Measuring tape.
Step 1: Collect The Tools You Need And Do Your Homework.
When planning to measure for your windows and doors Edmonton, you must be aware of what you want to achieve. To know the tools that you will need, you can browse on various doors and windows websites and also watch YouTube videos. Before you start measuring your windows, it is important to visit your local hardware and ascertain that you have everything you need.
Step 2: Measuring the Height.
This should be the first measurements you should take. Here you will need the level, pencil and notebook, and the main tool, the measuring tape. Start at the surface of the head to the window sill. Make sure these measurements start at the top points of each point, especially when dealing with vinyl windows and wood windows. These are more likely to bend if they are old. This is where the level comes in. However, when you are dealing with new windows, you may not need it, but you will not lose anything if you check.
Repeat the measurements several times and note the smallest number in your paper. Now, take that number and subtract 1/8 an inch. After deducting that fraction, you will have the actual measurement of the height of your windows.
Step 3: Measuring the Width.
Measuring the width for a replacement window is essentially like measuring for the height, only that in width you have to locate where to start taking the measurements. There are many assumptions when it comes to this, but all they need the use of a tape measure, pencil, and a notebook. If you measure windows from an older home, you will need to raise the sash of the window to make sure that the measurements you come up with are accurate.
To take the right measurements, you are supposed to measure between the jamb surface from each side of the window frame. Just like taking measurements for the height, you should also consider multiple measurements and choose the smallest number and then subtract 1/8 an inch. The resulting figure is the actual measurement of the width.
Step 4: Measuring Depth.
This is one of the most challenging aspects when it comes to measuring for the windows and doors Edmonton. And considering that depth is essential when it comes to replacement windows, you want to make sure that you get everything right. This will make sure that the window sits flush to its frame, instead of protruding out, which may result in problems with its functioning.
So start by measuring the whole dimension of the opening of the window to get the right figure for the depth. Now measure between the inside and also the outside the stops to get the correct measurement for the depth. Minimally, the measurement ought to be three and a quarter-inch, but if you get something different, your measurements might be off. After obtaining your measurements, double-check to ensure that your digits are consistent. Any slight mistake can cost you a lot of money, especially if you are buying many windows. Take note of these measurements in your notebook, and if you want, you can draw a diagram for a clear illustration.